HP is one of the reputed names in the market when it comes to printers. There is a wide range of HP printers for you to choose from including Laserjet, Deskjet, Designjet, PageWide Pro, and Officejet. HP printers are known for high-quality printing, but there are some problems that you might face while using them. After all, the printer is an electronic device that is susceptible to error codes. One of the most common error codes is HP printer error 59.f0.
What is HP Printer Error 59.F0 and its causes?
HP Printer Error 59.F0 is an error code that occurs when there is an issue in the internal motor of the printer. The two main reasons behind this problem are:
- Transfer alienation failure – It happens when the Intermediate Transfer Belt (ITB) is stuck and unable to rotate.
- SR9 sensor issue – Also known as Sensor K, SR9 is the primary sensor responsible for the transfer-roller-disengagement. SR9 sensor issue occurs when the transfer roller has worn out or the fuser drive assembly is not functioning properly.
How to troubleshoot HP printer error 59.F0?
Solution 1 –Reset the printer:
- Press the ‘Power’ button to switch off the printer.
- After a few minutes, turn on the printer.
- Keep waiting for the revitalization of the HP color jet printer.
- If there is any Surge Protector, remove it.
- Also, remove the Printed Circuit Board Assembly (PCA or PCBA).
Solution 2 – Reset the ITB of HP printer:
- Check the internal connections of ITB, especially the alienation sensor using Manual or Paper Path Sensor.
- Reconnect the ITB connectors.
- Run the sensor test to check the ITB contact/alienation drive.
- Now, you can reconnect the connectors of the primary-transfer-roller disengagement motor.
- If the primary-transfer-roller disengagement motor is not functioning correctly, replace it.
Solution 3 – Test the ITB
If the HP printer error 59.F0 continues to bother you, then it is advised to remove the ITB and test the ITB gear and paper sensor flag manually:
- Rotate the ITB gear and notice if there is any change in the flag when you turn the white gear.
- Replace the ITB if the flag is damaged.
When the ITB gear and flag are working perfectly, follow the below procedure for Manual Sensor Test:
- Remove the ITB gear.
- Check the Sensor SR9 located inside the ITB cavity and navigate to the Control Panel.
- Press the ‘Home’ and ‘Down’ arrow buttons to view the diagnostics menu. Click ‘OK.’
- Select ‘Manual Sensor Test’ and hit ‘OK.’
- Look closely inside the ITB cavity and release the SR9 flag.
- Press the flag and check the display for the sensor response.
- If the sensor toggles between 0 and 1, then it is fine. But if it doesn’t toggle, you have to get the sensor replaced.
When you find yourself in this troublesome situation, you can use the methods mentioned above without any doubt. But in case these solutions don’t work, contact the HP Support team or visit this link 123.hp.com for additional help. HP has an exemplary team of professionals who will address your technical problems and suggest the most relevant solution for your HP printer error 59.f0.